Tired
of your fuel cap leaking?
Need a new grommet without purchasing a tank?
Need better ventilation
for larger motors?
Solve all these problems with the SnappyRC Ultimate Fuel Kit for the
HPI Baja 5B 5T and 5SC!
Assembly:
Cut
Tubing to approximate length
14” pickup tube 9” return tube
1” vent valve tube
Use
2 cycle oil to lubricate the grommet and tubing, it is a tight fit!
The pickup tube should be approximately five inches through the
grommet. Install fuel pickup filter clunk. Return and vent
tubing
should less than half an inch through the grommet.
Lubricate the grommet with 2 cycle oil and install in tank.
Connect the pickup tube to the bottom carburetor nipple.
Connect the return tube to the top carburetor nipple.
Install the check valve in the vent tube. The Check Vent should be
mounted vertical for best performance.
Remove
old guts from gas cap and plug vent hole:
Tapping the hole and inserting a set screw is recommended.
“SealAll” or similar fuel resistant sealant will also work.
Reuse the cap guts or install the new cap gasket.
If
using FFRC brass fittings, add a small piece of tube where they
pass through the grommet for a tight fit.
Kit
includes:
- 3 hole Fuel Tank Grommet
- Billet Aluminum Check Valve
Vent*
- Heavy Duty Fuel Cap Gasket
- Instructions & Sticker
*The new
Billet Aluminum Check valve is safe for all fuels including
ethanol.
The original kit included a plastic check vent that was not for
ethanol.
|
